Samsung MS28 not Scaned

[CrossBox]

hi,

after flashing my drive with xtreme 5.2d something goes wrong with key transfer into the hacked.bin !
Now the Box shows E64 with one red flashing light.

when i try to reflash the MS28 (VCC Method) it doesnt work because MTKFlash (NF4 patched) cant find the Drive anymore!

it only shows:

1: IDE Pri Master

any idea ?

thx CrossBox

[glaze83]

a wire most likely is not connected--make sure all the cables are in.

[CrossBox]

everything iss fine !!

SATA PC-> Samsung Drive
Power 360->Samsung Drive

Swich iss Off when i turn ON the 360.

[glaze83]

everything iss fine !!

SATA PC-> Samsung Drive
Power 360->Samsung Drive

Swich iss Off when i turn ON the 360.

I'm talking your eject motor cable from the pcb of the drive to the motor and also your worm drive motor cables.

[CrossBox]

only the board iss connected! the drive hardware is disconnected.
1st flash it works fine. mtkflash found 3 devices! 1x IDE 2x SATA

in HitachiSamsungTutorialV41Merged.pdf everything (motor, laser etc) iss disconnected too.

greetz

[glaze83]

your vcc point is not connected then. Use a wire to connect the points where the 0 ohm resistor used to be. They have to be connected first for your bios to find the drive. When you're in dos you can turn off the 360 and boot it up with the vcc disconnected and then quickly connect the points and hit enter on your mtkflash command.

But the point is, the vcc must be connected when your bios looks for the drive.