360 slim dead

[lapht]

Hello everyone!
Two months ago I tried RGH on my Trinity Console but after many attempts I killed it
I want to resuscitate my Xbox and I read a lot of topics about STBY_CLK, HANA, R3B15 and its trace. I checked the resistor and I replaced it but xbox won't turn on. When I try to turn the console, it sounds but it not turn on the leds. The trace seems ok and the tester beeps when I check it. This problem came up when I tried to desolder the STBY_CLK wire.. Nandpro with USB SPI won't recognize the nand. I think the problem is the HANA chip, how can I check this chip?
Thanks a lot and sorry for my bad English but I'm Italian.

[Xb0xGuru]

The problem will be with STBY_CLK. Pics of your soldering would be useful about now.

[lapht]

I removed the wires and the Coolrunner when the console died.. The pads Are ok

[Xb0xGuru]

I removed the wires and the Coolrunner when the console died.. The pads Are ok

What makes you think I'm asking about your Coolrunner?

The STBY_CLK line is damaged. Can you post a pic?

[lapht]

Hello.. sorry for late.
There are the pics of HANA and STBY_CLK.


I've checked that line, volts and continuity are ok. Is there a way to verify the operation of this chip?

[Xumpy]

Lol, I would check those lines again. I would start by cleaning up all the mess that's on that board.

The resistors that are damaged (I see 4 resistors that might be damaged) should read 33ohm (I think they all should read that value).

The hana chip is probably fine. I would check all those pads. Not only for continuity but also for shorts and correct values of resistors.

Regards

[lapht]

Hello, now I'm on holiday but in two days I'll go to home and I'll check all the resistor.
Thank you for the answers.