My Xbox 360 doesn't turn on anymore

[playonlcd]

Hello,

I am experiencing a strange problem; i have done some RGH till now, but this one is failing at the end

The subject is a falcon
Installed, glitcher, flashed latest image 14699, all went fine with the motherboard outside the case.
For CPU_pll i am using the above resistor point and for sty_clk the FTR2 point; original points are a little damaged.

After flashing and see that the console glitches in dashboard 14699 put the mother board in the case and screwed the 8 crew  on xclamps  little tighter.

From here, the console dosen' boot anymore.
Removed the glitcher, started just once with RROD 2 leds form left red.

Wanted to write the stock image, but can't detect the nand. I  i am using LPC2148 to r/w nands.

The glither powers up, red led, but the console doesn't even powers up. Tried also with eject buton, no luck.

The processors could be cracked because i have tighten to much the screws?

I have infectus2 for nand flashing and i can desolder the nand.
BTW, can i flash the nand on a xenon and then put it back on falcon?
The nand is hynix.

Any ideas are welcome to debug the power up.


Thanks!

[playonlcd]

Got it started in the end.

2 screwx from CPU radiator were unscrewing when removed the screws from xlamp, form here 2 problems...they were bending the motherboard and the cpu was overheating.....auch.