Missing resistor and burned pad

[jbonzo]

Hello guys

I have been doing a lot of coolrunner installs in the last week or so but there was one i messed up bad!

To be fair it was a rrod revied falcon board i bought for 20$. It did not want to glitch and i was playing with it without being too careful. In some stupid way i managed to remove the resistor on the pic and burned off one of the pads (when trying to reconnect the reistor).

I just want to flash the original nand to it but without this resistor i boot to a rrod after some time.

Does anyone know where i can find a alternative point for the burned pad and the value of the resistor?

Thanks and please keep the ridicule at a minimum 

[jbonzo]

[backinblack]

Yeah, people like you tell people boards are had, "But I will give you $20 and for it." So far a few repair types have tried that.  If you hustled some kid like that then you deserve a busted board.  Find same board, remove part you need.  If that is the problem....

[jbonzo]

I would never swindle anyone! Just searched my local craigslist for a RROD board and payed what was asked for.

But I have found my answer and this thread can be closed.