Whoops, it was a bit late.http://tabon.ath.cx/~mastag/0401.zip
So this is what happened last night:
I unlocked my slim 0401 using my soldering iron, dosflash16 and the port on the back of my via 6421a card.
This went very smooth and it appears, that digging isn't as hard as it seems.
Of course I couldn't wait to go further so I spend an hour trying to dump it using my via.
No luck, if I enter vendor mode with MPX01 the flash will be recognized but the drive will not identify.
If I do not enter vendor mode the drive will identify but it will not detect flash.
So the via6421a is just not capable of doing a full dump it seems, not even when it's unlocked.
So I disconnected one of my raid disk (on ICH9R) and connected the sata cable to my slim (IDE compatible mode).
Then I started ms-dos 6.22, turned on my console and used dosflash16 again to dump my keys using the "liteon k" v3 key extract.
I got the above files:
Afterwards I erased my drive because I assumed the files were correct.
However jf1.89 is giving me a hard time.
It doesn't want to open my dummy.bin and gives me a parse error.
My key.bin seems to be correct though.
I tried to open the stock 0401 firmware for slim (by c4eva) in the source buffer and I manually edited the serial, barcode, laser serial etc...
But it still won't let me alter the dvd-key which is FFFFFF on the stock firmware.
So if anyone could create a stock firmware using the above files it would definitely help me