jtag will not boot anything help appreciated

[colorado]

so today i recieved a jtag back to me with a wire that came loose i fixed the wire and made sure it worked and it did. then i dicided aud clamp wiring would be better so i made a new image only with aud clamp smc and it replaced the old one (stupid mistake) after writing the new image i was greeted by e79 error. i made sure my wiring was correct and even tried aud_clamp&dvd  but still e79 on these fb images. i tried to write back the original i had and it just gives me a middle light no error or boot. i have made donor images and still either e79 or middle light. i have tried erasing the nand and just writing xell (with original wiring back of course) and yet still i get nothing but a middle light. i tried a diode in the jumper wire position and yet nothing. and this is a falcon
i would appreciate any suggestion that you can give as i have been working on this for hours.
thanks

i put this in another section and im thinking now i should have put it in this one :/

[bidomo]

And you patched your original untouched SMC with SMC_IO, right?

also, you indeed unplugged the power brick to ensure the new SMC comes in action, right?

you have to make sure the patching process goes as you want it, you have to make TMS/TDI match the new wiring in the smc.bin, else, you'll get nonstop E79