Start JTAG NXE with Remote Control

[adihash]

Hi!

I have an JTAG with DashLaunch automatically launching FreestyleDash.
Is it anyhow possible to boot to NXE if i switch the xbox on with the remote control?
Or could i make an shortcut from Freestyledash to load NXE?

Would be great because now i have to use the controller to load nxe if i want to watch videos.

Much thanks in advance!
Regards, adihash

[boflc]

no.

only thing you could do is remove fsd as the default setting in launch.ini; set it to be one of the button'ed launches.

[cory1492]

Yes. It's easily possible to tell the power up cause source (ie: controller X button, console power button, IR power button, IR X button, IR windows button, wired controller X button and a few others) it just needs a bit of code added to dash launch to do so and act on it.

[adihash]

Yes. It's easily possible to tell the power up cause source (ie: controller X button, console power button, IR power button, IR X button, IR windows button, wired controller X button and a few others) it just needs a bit of code added to dash launch to do so and act on it.

Would be great, but unfortunately my knowlege about xbox programming is not so good (but java )
I also don't know if DashLaunch's is opensource (i don't think so).
I hope someone will implement this feature sometime.

Thanks for your advice

[modguru]

the only thing you must do is  .
power on the console and when you see the xbox logo in the begining press and do not leave the RB button .
this is the default command to boot in nxe . 

[adihash]

I just saw that that function is now implemented in the new dashlaunch 
Big thanks for adding that feature!

- "remotenxe" option added to ini(thx adihash!)
- windows button on remote always boots to NXE/media center now(thx adihash!)

greets,
adihash