Jasper Board issues with Xellous

[hyrific]

On my journey to Jtag I have successfully installed my ltp Cable I am assuming I have a 16 meg jasper as my xbox did not have any internal memory shown on my dashboard config.


I have dumped by Key Vault with Nandpro lpt: kv.bin 1 1 Did this a few times all matched.



I have dumped my rawconfig with Nandpro lpt: -r16 rawconfig.bin 2de 2  DId this a few times all matched.

I flashed the jasper Xell file jasper 6723 hack using nandpro lpt: -w16 jasper_6723.bin 0

I then flashed my KV with nandpro lpt: -w16 kv.bin 1 1

I then supposedly updated to xellous with

nandpro lpt: +W16 xell-1f.bin 30

When I boot my xbox it does load into Xell but not Xellous.  AND it will NOT pull a DHCP address from my router.  It will show me my DVD key and CPU key.  It does not show HTTPD either.

What the hell is going on?  DO I have a big block nand and just didn't know it?  All the big block read commands error out when I have tried them.   I tried installing the Xell for Falcon Board as I thought maybe this was it but it red ringed and didn't even load. 

SO why isn't Xellous loading up?  Why isn't Xell able to pull DHCP?  Are there something wrong with my commands?

Any help would be greatly appreciated.

[littlestevie360]

write it with "nandpro lpt: +W16 xell-1f.bin 40" that will solve the issue.
the 30 address is backup xell, or also where you would write it on an xbr image

[hyrific]

That fixed it!  I now have a fully working jasper xbr xbox.