error 0020 fan mod(xbreboot console)

[consoledonk]

Was installing another fan to keep it cooler,I kept testing to make sure all steps taken that the fan was done right.
I put it back together and got 3 red rings 0020 error

I xclamp mod with no help (5 times)
Heat Gun (no help)

No soldering with fan mod.

It did fire up with the extra fan attached before i installed the shell case.
Would the wires from jtag cause this?

It worked great before this,was just keeping it cool

Anyone with any ideas?
I would most likely try anything to get it going

[rolf2]

Would the wires from jtag cause this?

yes

[jelle2503]

JTAG wiring can be kept in place AT ALL TIMES and will not error if you have original dashboard..

[rolf2]

TMS and TDI have on-board pullups, so if you don't drive it high (instead, drive high-Z), it should be fine without level shifter.

TRST however has a pulldown. Bridging it with J2D7 should work in theory, but failed on my xenon (got error 0020). A diode did the trick, but I can't explain why it didn't work without. Too high voltage?

[jelle2503]

never had a problem with any console with jtag wiring in place..

[ReverseAffect]

unless he has the wiring on the bottom and something is touching.....
did you heat gun the top enough?
did you re-pull the board and try it..a warp can cause this to....

[consoledonk]

Where to start?

It is error **0110** not 0020!

but again I tried everything but come up empty,

pulled board back out redid all wiring ,xclamp again,reflowed again nothing

Any other ideas?
I am up for anything right now,as I am ready to throw it in the garbage!

The board is just dead ,flash red lights on power up,

Thanks Guys