Could not read Jasper nand xenonboards dumps fine

[isnemid]

I did dump many nands of xenonboards fine.
Got one jasper to try and nandpro give me the could not read nand error.
I use nice clean wiring and no resistors, i use the same 1N4148 diode on the board side
i used before.
Only thing i did not, is using the jtag wires because its maybe not exploitable.
Should i try again with diodes and resistors that not seems to work dumping my xenonboards?

Thanks in advance! and sorry for my english 

[Gazcoigne]

JTAG wiring makes no difference to reading writing not required for initial read

check the connections to the lpt header port also i have had one work loose b4 and spent ages looking at the board instead of the lpt plug.

[isnemid]

Thanks, i checked all my wiring and its fine.
Is it possible the resistor/diode setup that dont work on the xenon boards
works on the jasperboards fine?

[isnemid]

Changed to switch diode n914 and added resistors to stop reading errors 47ohm seems to work:)
Flashdumptool gives cb 5770 cd 5770 ce 1888
Flashed xbr jasper16a 8955 3 a few times and xell but i cant boot xell,
so there is no way to get the dvd-drive key?

I don't like to play only xbla games  



*edit for search

[Arakon]

if XBR works, then xell works too. just use eject to get to xell (turn on with eject, drive has to be installed and drive tray has to open freely)

[isnemid]

if XBR works, then xell works too. just use eject to get to xell (turn on with eject, drive has to be installed and drive tray has to open freely)

You are the best, how can i mis that? i was switching keyboard and controller al the time backport frontport
again and again.
You just give me a no more rrod homebrew Jasper Thanks Thanks Thanx 

[littlestevie360]

CB 5770 is a falcon CB and not a jasper