Hard drive migration - only 2 out of 3 profiles show up?

[coreyinoz]

Hi All,

I'm having an issue where one of my profiles isn't showing up after copying from my old 120GB to my new 320GB.

Setup;

Falcon XBR 8955_3a
Internal MS 120GB
Internal WD Scorpio 320GB formatted in XBR

I used Magnus Hydra's guide to set up my 320GB after formatting. Partitions 0,2,3 show up, with xbox1 files intact. Then did this;

Connect 120GB and an external USB FAT32 drive
Use Viper360 to copy all from HDD1\ to USB
Shut down
Connect 320GB and the external USB FAT32 drive
Use Viper360 to copy all from USB back to HDD1\
Reboot

All transfers seemed to go properly, no lockups or other issues with the transfer. All files show up where I pasted them.

Now everything shows up in NXE dash EXCEPT one of my profiles. All my NXE installed games, all of my Arcade games, and 2 out of 3 profiles. The kick in the pants is that it's the 3rd profile I really want (the main one, the first that was created on this box).

I checked the 320GB when connected as HDD1\ and you can see all three profile folders under \Content\ and all seem to be intact.

I tried re-doing the copy/paste of the one profile not working... same thing.

Any troubleshooting ideas? Sorry to be spamming the tech support board, but I'm really close.  This is pretty much the last step for me on the long road to doing my own XBR install from scratch.

Thanks to all the smart guys here, everyone has been a big help.

coreyinoz

[Gazcoigne]

try moving the files with xplorer360 on PC? long shot!!

[coreyinoz]

Thanks for the tip. I'm willing to try anything... I really really don't want to lose that profile, lol.

I'll try xplorer360 tonight, I hex edited it so it can access my 320...

coreyinoz