Freeboot doesn't boot on my cygnos v2

[node21]

I'm hoping someone can point me in the right direction.

I've just finished installing my new cygnos v2 on my xenon.  Used xell to get my cpu key.

Built a freeboot and flashed both to the correct NANDs.  Now, if I power on with the eject button, it properly boots into Xell, but if I power on normally, it doesn't make it to the new dash.  Instead, it behaves properly (the blue light comes on on the cygnos, and I can see in the cygnos toolbox that it's trying to switch:

 / _|_ __ ___  ___| __ ) / _ \ / _ \_   _|
| |_| '__/ _ \/ _ \  _ \| | | | | | || |
|  _| | |  __/  __/ |_) | |_| | |_| || |
|_| |_|  \___|\___|____/ \___/ \___/ |_|
                [v0.02 - coded by ikari]

!SWITCH
Booting.


But, that's it.  At that point, only the center light is on on the Xbox, and it doesn't do anything else.


Thoughts?

Thanks.

[barnhilltrckn]

Was your dump good? any bad blocks? try and rebuild the image and flash again. trial and error will be the best way to figure it out honestly.
 I flashed xbr to my xenon's nand about 3 times before i got it right.

[node21]

Good dump....twice in a row, no bad blocks.

I've flashed my dump to the cygnos NAND and booted from it with no problem as well.

[barnhilltrckn]

Well i wish i could be more help but i dont have any experience with cygnos as i dont own one. maybe someone else here will jump in and help out. 

[node21]

It was fine all along... I just hadn't left it off for long enough to clear the SMC stuff.