lite on 93450c problem

[mosses]

hi
 i followed MRA method for 93450c dump it worked like a charm ... but that is no end to my story
when i tried to open the dump in jungleflasher using open target firmware tab

i get the following error "this is not a valid target f/w file"

and the file size of dump was just the rite 256k (if it might help i could upload the dumps )

after numerous tries with dumping i finally was able to see the key and i thought thats it boy  i have done it but !!!  when i spoofed the key on my spare benq all i get is annoying play dvd ..

1st key BDB796D5395FCB6CBEE997E2B9F1E7C9


so i thought maybe the resistor might be the one causing all that trouble i changed it from 22 ohm to 18 ohm  and to my surprise when i get the dump i get another key totally different from the previous one ..

2nd key D13D75058CAFBAE6D1A2C78AB6AD5F7B

tried the spoofing on benq still it isnt valid now i m kinda stuck in between..

is there any suggestion wat the problem might be and how to get a valid key i have dumped the key more like a 50 times now still no valid key and the keys are changing too

its giving me a lot of headache lately..

pls help

[MRA]

No idea whats wrong there just try another PC, and try dumping it in Dos with Dosflash. If you still have no success send me your dumps via PM and i´ll check them.

[mosses]

thanks for the prompt reply dosflash doesn't recognize the chip already checked on another pc key is not the same every time its a different one most of em dont even open on Jf.. i will upload the dumps and send u a link via pm.

i will be really obliged if u help me through it..

[kainy]

Lower the resistor more, and keep trying in DOS with dosflash. I personaly have more faith in it. As I read you can go down to 10ohm resistor. And of course check all the work on the drive, especially the cutting of the traces. Good luck!