JTAG / SMC XeLL Hack Xeon 1RL E79 problem

[Ded Games]

Hello everyone, I hope you can help me.

I'm trying to JTAG / SMC XeLL Hack into a Xeon that lost the DVD-KEY

Your kernel is 6xxx and your CB 1903 is

I made all connections perfectly, I called the 330ohm resistors, all ok, I made the extraction of Nand and everything ok.

When you put it on NAND Hack the e79, I have tried with various NAND Hack, I tried to "New Nand Hack Xeon" I tried to "Nand Hack 1920", I tried to "Nand Hack 1921" and always get 1RL e79 !

If I put the Original NAND, he returns to work ok.

I checked the wires, solder and components, it's all 100% ok, I tried over 10 times, and have tried to re-weld it again, and always get 1RL e79.

I upload my Nand Original: http://www.megaupload.com/?d=NL2ZM7AR

Some know of anything I can do?

Thank you.

[l_oliveira]

E79 = Resistors placed wrong, broken or missing. There's no other reason for that.

[Ded Games]

You sure about that, refills solder the resistors are 3 times are ok, and the resistor is identical to the photos and is 330ohm.

Thank you.

[Ded Games]

Right now, I just installed new 330ohm resistors, with new wires, cleaned the whole plate before welding, the welds left 101%, and the result was E79 !!!!!
I do not know what to do, I have spent hours and hours checking all the contacts and remaking the recording Nand and it's all ok, and I always get E79 !!!!!!!!!!!

Thank des already and I hope you can help me.

[l_oliveira]

Look, The hacked image don't have dashboard files. If the JTAG command don't reach the GPU, the magic does not happen and kernel tries to boot the normal way, don't find matching dashboard files for it and crashes at E79 screen.

something is wrong with your resistors or the XSB chip.

[Ded Games]

Already this Ok, I started to install the resistor on pin 1 instead of pin 2.

The Xella worked perfectly.

Thank you.

[kakelkund]

Already this Ok, I started to install the resistor on pin 1 instead of pin 2.

The Xella worked perfectly.

I have the same problem u had with the jtag hack. Can u please explain what u mean with this?
Pin 1? Did you use other pins than the examples on the net?

Regards

[maximilian0017]

Already this Ok, I started to install the resistor on pin 1 instead of pin 2.

The Xella worked perfectly.

I have the same problem u had with the jtag hack. Can u please explain what u mean with this?
Pin 1? Did you use other pins than the examples on the net?

Regards

He just wired the resistors wrong, just take a good look at the pictures posted everywhere here

[b3astmodz]

i have this same problem this is my 6th jtag and never a problem till now the dash is 7371 and cb is 1903  my connections are perfect. and i have e79 after flashing xell but when i go back to orginal its fine thanks in advance