how hard is it to read a readme? not very.
Instructions on flashing a LiteOn with JungleFlasher are as follows:
1: Hookup LiteON to sata port and power drive
2: In JungleFlasher select MTK Flash 32 Tab.
3: Select correct port (see above tutorials for figuring out the correct port)
4: Hit Lite-On-Erase button. NOTE - This is done AFTER you have already successfully transferred your inquiry.bin / identify.bin / key.bin files!!! Please read the Prompts VERY carefully! It is important to power cycle the drive at the correct moment to prevent your computer from freezing with VIA cards.
5: After power cycle, drive should return status 0x72 and display Flash information. If it does not, click Device ID and power cycle as prompted. If still not successful then you did not successfully erase the drive.
6: Once Flash information is displayed, you are ready to write! Go to firmware tool 32 tab and select "Load from dump files" and select your key/inquiry/identify .bin files. Then select ix15-liteon.bin after pressing "Open Target Firmware". Press "Spoof Source To Target". Then "Save to File" and save your CFW.bin.
7: Go back to MTK Flash 32 tab and select Write. It should automatically take the liteon firmware you loaded in the Firmware 32 tab and flash to the drive. It will automatically verify flash. If verified your done