infectus2+addon timing attack

[8ig80y]

After some reading some people have claimed that infectus2+addon works and some people have said it is broken? before going into the long and painful process of building the picboard for dgtool i want to verify if this is true.

I've gotten myself an infectus2. Actel chip on top reads a3p125. When i use programmer 0.0.3.8 b2 it says my loader is 0.28. I go into Actel-Firmware, select NAND programmer, click update . doesnt do anything. however i then go to tools-> open infectus then load the dat file from http://www.infectus.biz/downloads/INFECTUS2-A3P125.rar and click program. It works and i see nand programmer in the bottom left.

Then i go back to Actel Firmware. select postbus addon. click update. Does nothing. I try to program it by loading the postbus addon dat file in INFECTUS2-A3P125.rar  and it doesnt upgrade and tells me the id does not match.? I'm thinking it may be that the dat file is for a3p060 chips? Is there one that actually works for actel a3p125 chips?

Some people have warned not to use the latest infectus programmer (version 0.0.3.9 and up i think ?)which installs loader 0.32? Has anybody gotten the higher versions of the programmer to work? They seem to have firmwares for a3p125?

Has anybody successfully executed the timing attack with idgtool and a3p125 infectus 2 + the postbus addon that was sold by infectus? If you have ,could you help me out by listing the the loader, programmer and dat file versions you've used?

Thanks for reading!

[cjack]

Problems here too. I have 2 Infectus2 and all 2 gives me a "A973" x360 nand flash code instead of "AD73", so I cannot write and read it..........I think is a firmware problem.
You have already downloaded the RAR with all APA125 firmwares inside so I Hope that Team Infectus will fix al this bad bugs SOON!
Good Luck