|
3
|
Xbox 360 / Tech Support 360 / Xbox not powering on
|
on: July 08, 2009, 05:59:22 PM
|
One of my xbox 360 won't power on after the pad for the U point was accidentally ripped off when a person at my house tripped on the wire. Please refer this picture for the U point. http://www.xbox360-hacks.com/images/x360-bios-flasher.jpgAfter looking at the pinout for the NAND and traced the points using alt diagrams, U point appears to be leaded to the ninth pin of the NAND, which is CE. (Refer to the following diagram) http://pictures.xbox-scene.com/xbox360/infectus/Diagrams_NAND_Downgrader.jpgWhen my Xbox is plugged in, the Infectus LED on the USB board lights up (opposing to not lighting up in case of a bad flash), and the NAND appears to be accessible in the Infectus programmer. I have tried to reflash the NAND, but apparently, it does not help. Are there any alternative ways to re-route the CE point on the back of the motherboard? |
|
|
|
|
5
|
Xbox 360 / Tech Support 360 / Re: xclamp fix. now E71 error please help
|
on: July 08, 2009, 05:42:52 PM
|
Your dash.xex is corrupt.
If you can read the flash somehow, flashtool will confirm it.
You can probably repair the image with a hex editor, if you can find another dump of same version, by carefully replacing the blocks that are missing. Then reflashing.
Read |
|
|
|
|
13
|
Xbox 360 / XboxHacking - General / Infectus Spansion UNK 0101??
|
on: July 07, 2009, 04:56:01 PM
|
|
I am getting this error when soldered my infectus 2 on my xbox 360 as a nand flasher. I am positive that my wirings *should* be correct. Since i had previously flashed a wrong dump last time, i am using the "Bad flash method". Without the 3.3v powerline connected, i get 1111. When both 5v and gnd are connected to the xbox mobo, i get AAAA. With both 5v and gnd desoldered, i get FBFB. With just 5v, i get FFFF Any solutions?
|
|
|
|
|
Show Posts
Dilber MC Theme by HarzeM